How to Measure for Your SunSetter Awning. It takes only a few minutes...

SunSetter Lateral-Arm Awnings (Motorized or VISTA models) Measuring Instructions.
For Model XT's see below

To get the right size SunSetter Lateral-Arm Awning for your deck, please measure your deck or patio following the easy directions below. We suggest you PRINT OUT these instructions and take it with you. You can leave your computer on while you go measure now, or you can exit the website and come back later with the measurements.

1. Measure the height of the wall where you want to install your awning. You need at least 7 ft. 6 in. from your deck or patio floor to the bottom of any roof, eave, or overhang to fit the SunSetter Lateral-Arm Awnings. (If you don’t have this much clearance, you can install our Model 900XT or Model 1000XT.)

2. Measure along the side of your house to decide how wide an awning you want. The SunSetter Motorized awnings comes in pre-cut widths from 10 ft. to 20 ft. in one-foot increments. The SunSetter VISTA awnings come in pre-cut widths from 10 ft. to 18 ft. in one-foot increments. With the exception of the 10' awning, which measures 123" left to right, all other Lateral-Arm (Motorized or VISTA) awnings measure exactly like their defined size . Example, a 12 ft. awning is 12 feet wide. The actual fabric width is 4½" less than the total awning width.

3. Measure to make sure you have at least 8 inches of clear, unobstructed space horizontally along your wall where the awning will fit against the house.

Model 1000XT or Model 900XT Measuring Instructions
To get the right size Model 1000XT or Model 900XT for your deck, please measure your deck or patio following the easy directions below. We suggest you PRINT OUT these instructions and take them with you. You can leave your computer on while you go measure now, or you can exit the website and come back later with the measurements.

1. Measure the height of the wall where you want to install your awning. You need at least 7 ft. from your deck or patio floor to the bottom of any roof, eave, or overhang to fit the Model 1000XT, and at least 6 ft. 8 in. to fit a Model 900XT. Be sure to allow clearance for doors, light fixtures, electrical outlets, etc. You can install these awnings up to 10 ft. off the floor.

2. Measure along the side of your house to decide how wide an awning you want. Both the Model 1000XT and Model 900XT come in pre-cut widths from 7 ft. to 20 ft. in one-foot increments. If you have railings on the deck or patio, measure between the railings to make sure the awning support arms will fall inside the railing.

For example, a 12 ft. wide awning needs a space of at least 12 feet to fit inside the railings. The actual fabric width is 10 in. less than the awning width.